This stacked lamp was inspired by a very expensive designer lamp I found online (it was 650 euros), I decided to make my own using free software, then printing the cutting templates out on an office printer.
I’ve included templates of this design, so you can make your own with the tutorial provided on Instructables.
More info: Instructables
Stacked Lamp
Here’s the finished lamp with the slices rotated.
Print and cut template
Here is the template. I cut out the shapes, then I taped the pieces together.
Glue to wood
The templates were glued to the wood using spray adhesive.
Cut shapes
Print paper template and stick to wood. Cut out with bandsaw or jigsaw. The center can be cut with a hole saw.
Sand endges
Sand edges starting with coarse grit sandpaper and moving up to fine grit for a nice finish.
Sand plastic tube
Clear plastic tube was sanded with fine grit sandpaper to give the diffuse glow. After sanding the tube was buffed with a plastic souring pad to soften the appearance.
Fit tube to base
Electrical cord with switch was attached to underside of base, tube was fit on top and pieces were stacked to create lamp.
I decided to coat the wood with boiled lindseed oil for a nice finish without taking away from the look of the wood grain, but leaving it uncoated is just fine, too. This stacked lamp looks amazing, and can be changed to look completely different at any time
Happy Stacking!
Stagger, flip, swirl – any way you stack these slices is sure to satisfy!